1 / 3
MIXER TAP SHORT
Metal Folding Hot/Cold water Mixer tap. This very low profile tap suits the Dometic CRAMER sinks with fold down lid.
- Suits 40mm hole cut out
- Minimum height required above mounting base = 25mm
- 160mm spout from pivot point to end of spout
- 45mm in height from bench / sink top
- Female 1/2 inch BSP thread on hot and cold connectors
- Suits 40mm hole cut out
- Minimum height required above mounting base = 25mm
- 160mm spout from pivot point to end of spout
- 45mm in height from bench / sink top
- Female 1/2 inch BSP thread on hot and cold connectors
Metal Folding Hot/Cold water Mixer tap. This very low profile tap suits the Dometic CRAMER sinks with fold down lid.
- Suits 40mm hole cut out
- Minimum height required above mounting base = 25mm
- 160mm spout from pivot point to end of spout
- 45mm in height from bench / sink top
- Female 1/2 inch BSP thread on hot and cold connectors
- Suits 40mm hole cut out
- Minimum height required above mounting base = 25mm
- 160mm spout from pivot point to end of spout
- 45mm in height from bench / sink top
- Female 1/2 inch BSP thread on hot and cold connectors
$85.00
MIXER TAP SHORT—
$85.00
Description
Metal Folding Hot/Cold water Mixer tap. This very low profile tap suits the Dometic CRAMER sinks with fold down lid.
- Suits 40mm hole cut out
- Minimum height required above mounting base = 25mm
- 160mm spout from pivot point to end of spout
- 45mm in height from bench / sink top
- Female 1/2 inch BSP thread on hot and cold connectors
- Suits 40mm hole cut out
- Minimum height required above mounting base = 25mm
- 160mm spout from pivot point to end of spout
- 45mm in height from bench / sink top
- Female 1/2 inch BSP thread on hot and cold connectors
